Camshaft Cover Removal
WARNING: This page is about a different variant/trim than selected.
Remove the PCV hose assembly (1) at the quick-connect fittings.
Remove the engine coolant air bleed pipe (2), bolt (1), and O-ring (3). Inspect O-rings and discard if necessary.
Remove the oil level indicator (3). Inspect and replace the oil indicator O-ring seals (4), if necessary.
- Remove the camshaft cover heat shield (2) and bolts (1).
Remove the rear lift bracket (1) and bolts (2).
Remove the front lift bracket (2) and bolts (1).
Remove the ignition coils (2) and bolts (1).
Remove the camshaft position actuator control solenoid valves (2) and bolts (1).
Remove the vacuum assembly (2) and bolts (1).
- Remove the vacuum assembly gasket (3) and discard.
Remove the bolts (1), bolt (4), washer (3), and camshaft cover assembly (2).
- Remove and discard the camshaft cover gaskets and camshaft cover inner gaskets (5).
NOTE:
The heat shield may vary by model.
NOTE:
Ensure all camshaft cover gaskets, including the inner gaskets, are removed and discarded.