Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
For an overview of the component/system, refer to: Electronic Ignition System Description
| Circuit | Description |
|---|---|
| 5 V Reference | Regulated voltage supplied by the control module. |
| Signal | The control module input circuit has an internal resistance connected to 5 V. |
| Low Reference | Grounded through the control module. |
| Component | Description |
|---|---|
| K20 Engine Control Module | The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly. |
| M129 Intake Camshaft Profile Actuator M130 Exhaust Camshaft Profile Actuator |
The sensor contains a hall effect sensor that varies its output voltage in response to a magnetic field. The hall effect sensor is used for the following sensing application: M129 Intake Camshaft Profile Actuator or M130 Exhaust Camshaft Profile Actuator |