Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
For an overview of the component/system, refer to: Fuel System Description
| Circuit | Description |
|---|---|
| Control | The output circuit is switched to 12 V to activate the component. |
| Low Reference | Grounded through the control module. |
| Component | Description |
|---|---|
| A7 Fuel Pump and Level Sensor Assembly | The fuel pump has a DC motor that is controlled by a PWM signal to achieve the desired fuel pressure. |
| K111 Fuel Pump Driver Control Module | The control module K111 supplies the fuel pump with a PWM signal in order to achieve the desired fuel line pressure. |
When the ignition is turned On, the ECM sends a 12 V signal to the control module K111 to enable the fuel pump. If the engine is not started, the control module K111 turns the fuel pump Off after 6 s.