Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Remove the component: Q40 Turbocharger Bypass Solenoid Valve - Leave the electrical connector connected.
- Perform the scan tool control function: Turbocharger Bypass Solenoid Valve - On & Off
Verify the component opens and closes: Q40 Turbocharger Bypass Solenoid Valve
- If the component does not open and close
Replace the component: Q40 Turbocharger Bypass Solenoid Valve
- Go to next step: If the component opens and closes
- If the component does not open and close
- Verify a condition does not exist with the component: Turbocharger - Mechanical damage/Visible Damage
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- If a condition exists
- Replace the component: Q40 Turbocharger Bypass Solenoid Valve