Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Verify DTC P0697, P06A3 is not set.
- If any of the DTCs are set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If none of the DTCs are set
Verify the scan tool parameter:
- APP Sensor 1 = 0.8 to 4.5 V - The value should not spike or drop out while moving the sensor through the entire range.
- APP Sensor 2 = 0.4 to 2.5 V - The value should not spike or drop out while moving the sensor through the entire range.
- If not in the specified range or does not change
  Refer to: Circuit/System Testing
- Go to next step: If in the specified range and changes
Verify the scan tool parameter:
- APP Sensor 1 = The value should not spike or drop out.
- APP Sensor 2 = The value should not spike or drop out.
- Perform the action while monitoring the parameter:
- Wiggle the harness and connector: B107 Accelerator Pedal Position Sensor
- Wiggle the harness and connector: K20 Engine Control Module
- If the value spikes or drops out
  Repair as necessary - Wiring/Terminal(s)/Electrical Connector(s)
- Go to next step: If the value does not spike or drop out
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
All OK.