Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Verify no other DTCs are set.
- If other DTCs are set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If no other DTCs are set
Ignition - Cycle On and Off
Verify a click can be heard or felt at the following component(s) when the scan tool control function was commanded: KR75 Engine Controls Ignition Relay
- If a click cannot be heard or felt
  Refer to: DTC P0685-P0687, P0689, P0690, P1682, P16A7, P16AF, or P16B3
- Go to next step: If a click can be heard or felt
Verify DTC P163A is not set.
- If DTC P163A is set
  Refer to: Circuit/System Testing
- Go to next step: If DTC P163A is not set
All OK.