Conditions for Running the DTC

• DTCs related to the following system/component = Not Set
  • B9 Ambient Air Temperature Sensor
  • B66 Intake Air Temperature Sensor
  • B115 Vehicle Speed Sensor
  • G58 Evaporative Emission Purge Pump
  • Q12 Evaporative Emission Purge Solenoid Valve
  • Q13 Evaporative Emission Vent Solenoid Valve
  • Barometric Pressure
  • Engine Control Module LIN Bus 2
  • Output Speed Sensor
• DTC P0111, P0112, P0113, P0114, P10F5, P14A4, P14B6, U060F, U111E, U1346, U2011 = Not pending
• G58 Evaporative Emission Purge Pump = On - For greater than 14 s
• Ambient Air Temperature = 4 to 50°C (39 to 122°F)
• Barometric Pressure = Greater than 70 kPa (10.15 PSI)
• Engine Speed = 450 to 6750 RPM

  For the diagnostic to remain enabled: Engine Speed = 350 to 6850 RPM

• Ignition Voltage = Greater than 11.0 V
• LIN Bus = Active - Greater than 2 counts
• MAF Sensor = 0.0 to 30 g/s

  For the diagnostic to remain enabled: MAF Sensor = -5.0 to 35 g/s

• Scan Tool Device Control: EVAP Purge Pump = Not Activated
• Vehicle Speed Greater than 7.0 km/h (4.3 MPH)

  For the diagnostic to remain enabled: Vehicle Speed = Greater than 1.9 km/h (3.0 MPH)

Frequency the DTC runs = Continuously - After the running conditions are met