Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P1467

EVAP Purge Pump Speed & Desired EVAP Purge Pump Speed = Not within a calibrated range - For greater than 5 s

P1468

EVAP Purge Pump Speed = Greater than 240 RPM @ Commanded Off - For greater than 5 s

P1469

EVAP Purge Pump Speed = Less than -100 RPM - For greater than 5 s

P146A

EVAP Purge Pump Speed = Greater than 55000 RPM - For greater than 5 s

P148E

EVAP Purge Pump Voltage = Less than 3.5 V - For greater than 1 s

P148F

EVAP Purge Pump Voltage = Greater than 28.0 V - For greater than 1 s

P1490

EVAP Purge Pump Voltage & Ignition Voltage = Not within 2.0 V of each other - For greater than 1 s

P14A4

EVAP Purge Pump - Temperature = Greater than a predefined threshold - For greater than 8 s

U111E

Serial data message from component: G58 Evaporative Emission Purge Pump = Not Received - For greater than 1 s