LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 2.0L (LSY) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P1467-P146A, P148E-P1490, P14A4, or U111E >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC P146D, P146E, P146F is not set.
    • Go to next step: If none of the DTCs are set 
  3. Verify DTC U111E, U1348 is not set.
    • If DTC U111E is set and no other DTCs are set 

      Refer to: Circuit/System Testing

    • If DTC U111E, U1348 is set and other DTCs are set 

      Refer to: DTC U1340-U135F

    • Go to next step: If none of the DTCs are set 
  4. Verify DTC P1467, P1468, P1469, P146A is not set.
    • If any of the DTCs are set 

      Replace the component: G58 Evaporative Emission Purge Pump

    • Go to next step: If none of the DTCs are set 
  5. Verify the scan tool parameter: EVAP Purge Pump Supply Voltage Status = OK
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  6. Verify the scan tool parameter: EVAP Purge Pump Overtemperature = No
    • If not the specified state 
    1. Ignition/Vehicle - Off
    2. Verify the component location is free of debris, clutter or any obstruction that may reduce airflow which could cause an overheat condition: G58 Evaporative Emission Purge Pump
      • If a condition exists - Repair or replace as necessary
      • If no condition exists - Replace the component: G58 Evaporative Emission Purge Pump
    • Go to next step: If the specified state 
  7. Perform the scan tool control function: EVAP Purge Pump - On

    Verify a condition does not exist with the component: G58 Evaporative Emission Purge Pump - Turns Off

    Perform the action while monitoring the component:

    • Wiggle the harness and connector: G58 Evaporative Emission Purge Pump
    • Wiggle the harness and connector: K20 Engine Control Module
    • If a condition exists 

      Repair as necessary - Wiring/Terminal(s)/Electrical Connector(s)

    • Go to next step: If no condition exists 
  8. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC does not set 
  9. All OK.
scientia non olet · About LEMON Manuals