Conditions for Running the DTC

• DTCs related to the following system/component = Not Set
  • B14A Transmission Output Shaft Speed Sensor
  • B15 Transmission Internal Mode Switch
  • B25B Clutch Pedal Position Sensor
  • B26 Crankshaft Position Sensor
  • B34 Engine Coolant Temperature Sensor
  • B66 Intake Air Temperature Sensor
  • B74 Manifold Absolute Pressure Sensor
  • B75C Multifunction Intake Air Sensor
  • B106 Throttle Position Sensor
  • B107 Accelerator Pedal Position Sensor
  • B115 Vehicle Speed Sensor
  • Q17 Fuel Injector
  • Q38 Throttle Body
  • T8 Ignition Coil
  • 5 V Reference Circuit
  • Engine Misfire
  • Fuel Trim System
• Accelerator pedal not pressed.
• BARO Sensor = Greater than 72 kPa (10.4 PSI)
• Calculated Catalyst Temperature = Colder than 400°C (752°F)
• Engine Coolant Temperature = -12 to 72°C (10 to 162°F)
• Engine Run Time = For greater than 1 s
• Vehicle Speed = Less than 2 km/h (1 MPH)

Frequency the DTC runs = Once - Per cold start-up