LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 2.0L (LSY) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P1176 or P1177 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify the scan tool parameter:
    • {P1176} Fuel Pump Power Control Module 5 V Reference = 4.4 to 4.6 V
    • {P1177} Fuel Pump Power Control Module 5 V Reference 2 = 4.4 to 4.6 V
    • If not the specified value 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified value 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  4. All OK.
scientia non olet · About LEMON Manuals