LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 2.0L (LSY) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P1005 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    Some control module ground circuits may require up to 2 min after the ignition is turned Off before achieving a resistance reading of less than 5 ohms. In most cases the readings will drop below 20 ohms within 1 min indicating the control modules are going to sleep.

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: @ K111 Fuel Pump Driver Control Module
  3. Test for less than 10 ohms between the test points: Ground circuit terminal 22 & Ground
    • If 10 ohms or greater 
    1. Disconnect the ground connection: Ground terminal
    2. Test for less than 2 ohms between the test points: Ground circuit terminal 22 @ Component harness & The other end of the circuit @ Ground terminal
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Repair the open/high resistance in the ground connection.
    • Go to next step: If less than 10 ohms 
  4. Verify a test lamp turns On between the test points: B+ circuit terminal 7 & Ground
    • If the test lamp does not turn On and the circuit fuse is OK 
    1. Remove - Test Lamp
    2. Test for less than 2 ohms between the test points: B+ circuit terminal 7 @ Control module harness & Output terminal @ F35RA Fuse
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Verify the fuse is OK and there is voltage at the fuse.
    • If the test lamp does not turn On and the circuit fuse is open 
    1. Remove - Test Lamp
    2. Test for infinite resistance between the test points: Ignition circuit terminal 17 @ Control module harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: K111 Fuel Pump Driver Control Module
    • Go to next step: If the test lamp turns On 
  5. Ignition - On/Vehicle - In Service Mode
  6. Verify a test lamp turns On between the test points: Ignition circuit terminal 17 & Ground
    • If the test lamp does not turn On and the circuit fuse is OK 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Test for less than 2 ohms between the test points: Ignition circuit terminal 17 @ Control module harness & Output terminal @ F50UA Fuse
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Verify the fuse is OK and there is voltage at the fuse.
    • If the test lamp does not turn On and the circuit fuse is open 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Test for infinite resistance between the test points: Ignition circuit terminal 17 @ Control module harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: K111 Fuel Pump Driver Control Module
    • Go to next step: If the test lamp turns On 
  7. Replace the component: K111 Fuel Pump Driver Control Module
scientia non olet · About LEMON Manuals