Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0685, P0686, P0687, P16A7
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P0689, P16AF
- Ignition Voltage = Greater than 9 V
- Engine Controls Ignition Relay Command = On
Frequency the DTC runs = Continuously - After the running conditions are met
P0690, P16B3
- DTC P0685 = Not set
- Engine Controls Ignition Relay Command = Off - For greater than 2 s
Frequency the DTC runs = Continuously - After the running conditions are met
P1682
- Engine Controls Ignition Relay Command = On
- Ignition Voltage = Greater than 5.5 V
Frequency the DTC runs = Continuously - After the running conditions are met