Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

NOTE:

Cold Start-Up = Required

Engine - Idling
Verify the scan tool parameter: Cylinder 1 - 4 Current Misfire Counter = Less than 1
- If 1 or greater
1. Ignition - On/Vehicle - In Service Mode & Engine - Off
2. Verify the following conditions do not exist:
  - Fuel Pressure - Low/High - Refer to: Fuel System Diagnosis .
  - Fuel - Contaminated/Poor Quality - Refer to: Alcohol/Contaminants-in-Fuel Diagnosis
  - If a condition exists - Repair or replace as necessary
  - If no condition exists - Replace the component: Q17 Fuel Injector
- Go to next step: If less than 1
All OK.