Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify no other DTCs are set.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
- Verify the scan tool parameter: Throttle Body Idle Air Flow Compensation = Less than 90%
- If 90% or greater
Refer to: Throttle Body Cleaning
- Go to next step: If less than 90%
- If 90% or greater
- Engine - Idling - At normal operating temperature.
- Verify the scan tool parameter: Engine Speed = -100 to +200 RPM of the Desired Idle Speed
- Go to next step: If not the specified state
Go to next step: Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Go to next step: If not the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- Go to next step: If the DTC sets
Go to next step: Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
- Go to next step: If the DTC sets
- All OK.