Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the electrical connector: Q13 Evaporative Emission Vent Solenoid Valve
- Test for 10 to 30 ohms between the test points: Control terminal 1/A & B+ terminal 2/B
- If not between 10 and 30 ohms
Replace the component: Q13 Evaporative Emission Vent Solenoid Valve
- Go to next step: If between 10 and 30 ohms
- If not between 10 and 30 ohms
- All OK.