Conditions for Running the DTC

• DTCs related to the following system/component = Not Set
  • 5V Reference Circuit
  • B14A Transmission Output Shaft Speed Sensor/Vehicle Speed Sensor
  • B15 Transmission Internal Mode Switch
  • B26 Crankshaft Position Sensor
  • B34 Engine Coolant Temperature Sensor
  • B74 Manifold Absolute Pressure Sensor
  • B75C Multifunction Intake Air Sensor
  • B107 Accelerator Pedal Position Sensor
  • Q17 Fuel Injector
  • Q38 Throttle Body
  • T8 Ignition Coil
  • Engine Misfire
  • Fuel Trim System
• Accelerator pedal not pressed.
• Calculated Catalyst Temperature = 350 to 900°C (662 to 1, 652°F)
• {Cold Start-Up} BARO Sensor = Less than 70 kPa (10 PSI)
• Engine = Running - For greater than 1 s
• Engine Coolant Temperature = 10 to 66°C (50 to 150°F)
• Vehicle Speed = Less than 3 km/h (2 MPH)

Frequency the DTC runs = Once - Per cold start-up - Within 15 s