Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition/Vehicle - Off
Verify the following conditions do not exist:
- Q12 Evaporative Emission Purge Solenoid Valve - Incorrect connection/Incorrect installation/Leaking/Visible Damage
- Vacuum Hoses @ Q12 Evaporative Emission Purge Solenoid Valve - Incorrect connection / Incorrect installation/Incorrect routing
- If a condition exists
  Repair or replace as necessary
- Go to next step: If no condition exists
Ignition - On / Vehicle - In Service Mode
Verify DTC P0451 - P0454 is not set.
- If any of the DTCs are set
  Refer to: DTC P0451-P0454
- Go to next step: If none of the DTCs are set
Engine - Idling
Perform the scan tool control function: - EVAP Purge/Seal Not Venting
Verify the scan tool parameter: Fuel Tank Pressure Sensor = Less than 9.3 mmHg (5.0 in. H2O) - After 60 s
- If 9.3 mmHg (5.0 in. H2O) or greater
  Test or replace the component: Q12 Evaporative Emission Purge Solenoid Valve
- Go to next step: If less than 9.3 mmHg (5.0 in. H2O)
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Repeat the procedure starting at step 2
- Go to next step: If the DTC does not set
All OK.