Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P034A
- DTC P0335, P0336 = Not set
- Engine = Running - After an autostop event.
- Crankshaft position is being verified.
Frequency the DTC runs = Continuously - After the running conditions are met
P034B
- DTC P0335, P0336 = Not set
- Engine Speed = 400 to 2000 RPM
- MAF Sensor = Greater than 0.3 g/s
- Crankshaft Position Sensor = Signal received
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 4 s