Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0335 Condition 1
Crankshaft Position Sensor = No Signal - For greater than 4 s
Condition 2
Crankshaft Position Sensor = No pulses within 0.3 s
Condition 3
Crankshaft Position Sensor = No Signal - During 2 engine revolution(s)
P0336 Condition 1
Crankshaft Position Sensor = Signal synchronization lost 10 times within 10 s.
Condition 2
Crankshaft Position Sensor = Sync gap not detected - For greater than 0.4 s
Condition 3
Crankshaft Position Sensor = Sync gap not detected - Since last starter engagement - For greater than 1.5 s
Condition 4
Crankshaft Position Sensor = Not between 51 and 65 pulses - During 1 engine revolution(s) - For 8 out of 10 engine revolutions