Repair Instructions
WARNING: This page is about a different variant/trim than selected.
Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification
- Turbocharger Wastegate Actuator Replacement - M128 Turbocharger Wastegate Actuator
- For control module replacement, programming, and setup refer to: Control Module References
Additional Procedures
- Intake System Learned Values Reset
- Turbocharger Wastegate Learn
Perform only when the following component/system is replaced or serviced:
- K20 Engine Control Module - Replaced
- M128 Turbocharger Wastegate Actuator - Replaced
- Turbocharger - Cleaned/Replaced