LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LSY) - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures >> DTC P0201-P0204, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P1248, P1249, P124A, P124B, P2147, P2148, P2150, P2151, P2153, P2154, P2156, or P2157 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.

Test 1

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: X3 @ K20 Engine Control Module
  3. Test for infinite resistance between the test points:
    • {Q17A Fuel Injector 1} Control circuit terminal 69 & Ground
    • {Q17B Fuel Injector 2} Control circuit terminal 51 & Ground
    • {Q17C Fuel Injector 3} Control circuit terminal 71 & Ground
    • {Q17D Fuel Injector 4} Control circuit terminal 49 & Ground
    • If less than infinite resistance 
    1. Disconnect the appropriate electrical connector: Q17 Fuel Injector
    2. Test for infinite resistance between the test points:
      • {Q17A Fuel Injector 1} Control circuit terminal 69 @ Control module harness & Ground
      • {Q17B Fuel Injector 2} Control circuit terminal 51 @ Control module harness & Ground
      • {Q17C Fuel Injector 3} Control circuit terminal 71 @ Control module harness & Ground
      • {Q17D Fuel Injector 4} Control circuit terminal 49 @ Control module harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • Go to next step: If infinite resistance
    3. Test for infinite resistance between the test points:
      • {Q17A Fuel Injector 1} Control circuit terminal 70 @ Control module harness & Ground
      • {Q17B Fuel Injector 2} Control circuit terminal 52 @ Control module harness & Ground
      • {Q17C Fuel Injector 3} Control circuit terminal 72 @ Control module harness & Ground
      • {Q17D Fuel Injector 4} Control circuit terminal 50 @ Control module harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: Q17 Fuel Injector
    • Go to next step: If infinite resistance 
  4. Ignition - On/Vehicle - In Service Mode
  5. Test for less than 1 V between the test points:
    • {Q17A Fuel Injector 1} Control circuit terminal 69 & Ground
    • {Q17B Fuel Injector 2} Control circuit terminal 51 & Ground
    • {Q17C Fuel Injector 3} Control circuit terminal 71 & Ground
    • {Q17D Fuel Injector 4} Control circuit terminal 49 & Ground
    • If 1 V or greater 
    1. Disconnect the appropriate electrical connector: Q17 Fuel Injector
    2. Test for less than 1 V between the test points:
      • {Q17A Fuel Injector 1} Control circuit terminal 69 @ Control module harness & Ground
      • {Q17B Fuel Injector 2} Control circuit terminal 51 @ Control module harness & Ground
      • {Q17C Fuel Injector 3} Control circuit terminal 71 @ Control module harness & Ground
      • {Q17D Fuel Injector 4} Control circuit terminal 49 @ Control module harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • Go to next step: If less than 1 V
      • {Q17A Fuel Injector 1} Control circuit terminal 70 @ Control module harness & Ground
      • {Q17B Fuel Injector 2} Control circuit terminal 52 @ Control module harness & Ground
      • {Q17C Fuel Injector 3} Control circuit terminal 72 @ Control module harness & Ground
      • {Q17D Fuel Injector 4} Control circuit terminal 50 @ Control module harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V - Replace the component: Q17 Fuel Injector
    • Go to next step: If less than 1 V 
  6. Ignition/Vehicle - Off
  7. Disconnect the appropriate electrical connector: Q17 Fuel Injector
  8. Test for less than 2 ohms between the test points:
    • {Q17A Fuel Injector 1} Control circuit terminal 70 @ Control module harness & Control circuit terminal 1 @ Component harness
    • {Q17A Fuel Injector 1} Control circuit terminal 69 @ Control module harness & Control circuit terminal 2 @ Component harness
    • {Q17B Fuel Injector 2} Control circuit terminal 50 @ Control module harness & Control circuit terminal 1 @ Component harness
    • {Q17B Fuel Injector 2} Control circuit terminal 51 @ Control module harness & Control circuit terminal 2 @ Component harness
    • {Q17C Fuel Injector 3} Control circuit terminal 72 @ Control module harness & Control circuit terminal 1 @ Component harness
    • {Q17C Fuel Injector 3} Control circuit terminal 71 @ Control module harness & Control circuit terminal 2 @ Component harness
    • {Q17D Fuel Injector 4} Control circuit terminal 50 @ Control module harness & Control circuit terminal 1 @ Component harness
    • {Q17D Fuel Injector 4} Control circuit terminal 49 @ Control module harness & Control circuit terminal 2 @ Component harness
    • If 2 ohms or greater 

      Repair the open/high resistance in the circuit.

    • Go to next step: If less than 2 ohms 
  9. Verify a condition does not exist with the component: Q17 Fuel Injector - Refer to: Component Testing
    • If a condition exists 

      Replace the component: Q17 Fuel Injector

    • Go to next step: If no condition exists 
  10. Replace the component: K20 Engine Control Module

Test 2

    NOTE:

    Testing for steps 1 to 4 is performed at the connector X3 of the control module K20.

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: X3 @ K20 Engine Control Module
  3. Disconnect the appropriate electrical connector: Q17 Fuel Injector
  4. Test for infinite resistance between the test points:
    • {Q17A Fuel Injector 1} Control circuit terminal 69 @ Control module harness & Control circuit terminal 70 @ Control module harness
    • {Q17B Fuel Injector 2} Control circuit terminal 51 @ Control module harness & Control circuit terminal 52 @ Control module harness
    • {Q17C Fuel Injector 3} Control circuit terminal 71 @ Control module harness & Control circuit terminal 72 @ Control module harness
    • {Q17D Fuel Injector 4} Control circuit terminal 49 @ Control module harness & Control circuit terminal 50 @ Control module harness
    • If less than infinite resistance 

      Repair the short between the circuits.

    • Go to next step: If infinite resistance 
  5. Test or replace the component: Q17 Fuel Injector
scientia non olet · About LEMON Manuals