Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0121

Throttle Position Sensor 1 = Signal Stuck In Range - For greater than 1 s

P0122

Throttle Position Sensor 1 = Less than 0.33 V - For greater than 1 s

P0123

Throttle Position Sensor 1 = Greater than 4.75 V - For greater than 1 s

P0222

Throttle Position Sensor 2 = Less than 0.25 V - For greater than 1 s

P0223

Throttle Position Sensor 2 = Greater than 4.59 V - For greater than 1 s

P2135

Throttle Position Sensor 1, 2 = Not within 7-10% of each other - For greater than 1 s
Throttle Position Sensor 1, 2 Learned Minimum Greater than 5% - 5 V Reference

U0606, U0607

Serial Data circuit = Message Counter Incorrect/Too Many Pulses/Too Few Pulses