Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Throttle Actuator Control (TAC) System Description

Circuit	Description
5 V Reference	Regulated voltage supplied by the control module.
Serial Data	The control module input circuit has an internal resistance connected to 5 V. Digitally encoded information for communication between devices.
Low Reference	Grounded through the control module.

Component	Description
Q38 Throttle Body	The assembly has several functions: The throttle valve is actuated by a bidirectional DC motor. A spring pulls the valve to a rest or default position, in which the valve is almost closed. The throttle actuator motor can push against the force of the spring to open or close the valve. The more current flow through the motor, the more the valve moves. The throttle body assembly contains 2 potentiometer-type throttle position sensors. When the throttle plate moves, the voltage of one sensor goes up and the voltage of the other sensor goes down. This redundant design enables the ECM to detect if the 2 signals indicate the same throttle plate position.
K20 Engine Control Module	The control module contains a microprocessor used to process input data to control outputs. The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.

Component

Description

Q38 Throttle Body

The assembly has several functions:

The throttle valve is actuated by a bidirectional DC motor. A spring pulls the valve to a rest or default position, in which the valve is almost closed. The throttle actuator motor can push against the force of the spring to open or close the valve. The more current flow through the motor, the more the valve moves.
The throttle body assembly contains 2 potentiometer-type throttle position sensors. When the throttle plate moves, the voltage of one sensor goes up and the voltage of the other sensor goes down. This redundant design enables the ECM to detect if the 2 signals indicate the same throttle plate position.

K20 Engine Control Module

The control module contains a microprocessor used to process input data to control outputs.
The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.