LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.0L (LSY) - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures >> DTC P00EA-P00EC >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: B65 Intake Manifold Pressure and Air Temperature Sensor
  3. Test for 67 to 49882 ohms between the test points: Signal terminal 1 & Low Reference terminal 3
    • If not between 67 and 49882 ohms 

      Replace the component: B65 Intake Manifold Pressure and Air Temperature Sensor

    • Go to next step: If between 67 and 49882 ohms 
  4. Verify the value is within the range listed in the table: Temperature Versus Resistance - Intake Air Temperature Sensor
    • If not in the specified range 

      Replace the component: B65 Intake Manifold Pressure and Air Temperature Sensor

    • Go to next step: If in the specified range 
  5. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component: B65 Intake Manifold Pressure and Air Temperature Sensor

    • Go to next step: If infinite resistance 
  6. All OK.
scientia non olet · About LEMON Manuals