Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P0106, P0107, P0108, P2227, P2228, P2229, P2230, P227C, P227D, P227E is not set.
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Verify the scan tool parameter: Throttle Body Idle Air Flow Compensation = Less than 90%
- If 90% or greater
Refer to: Throttle Body Cleaning
- Go to next step: If less than 90%
- If 90% or greater
- Verify the following conditions do not exist:
- B65 Intake Manifold Pressure and Air Temperature Sensor - Leaking @ O-Ring - Missing/Visible Damage
- B75C Multifunction Intake Air Sensor - Contamination of the measuring element / Cracked/Loose Clamps/Visible Damage/Water intrusion
- B111 Turbocharger Boost Sensor
- Leaking @ O-Ring - Missing/Visible Damage
- Restricted - Moisture/Ice
- Skewed
- Q38 Throttle Body
- Coking/Loose Clamps/Visible Damage
- Restricted - Moisture/Ice
- Air Cleaner Element - Dirty/Restricted
- Catalytic Converter - Blocked/Restricted/Visible Damage
- Charge Air Cooler
- Leaking/Incorrect connection
- Restricted - Moisture/Ice
- Engine - Mechanical Condition - Refer to: Symptoms - Engine Mechanical
- Exhaust System - Leaking/Restricted/Visible Damage
- Intake Air Duct - Cracked/Loose Clamps/Restricted/Visible Damage
- Intake Manifold - Cracked/Loose Clamps/Restricted/Vacuum leak/Visible Damage
- Positive Crankcase Ventilation System
- Leaking @ O-Ring - Missing/Visible Damage
- Restricted - Moisture/Ice
- Incorrect connection/Leaking/Restricted
- Vacuum Hoses - Kinked/Leaking/Incorrect connection/Restricted
- Vacuum leak @ Engine - Oil Level Indicator and Tube/Oil Filler Cap
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- Verify the scan tool parameter:
- BARO Sensor = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- MAP Sensor = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- Turbocharger Boost Sensor = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- If not in the specified range
- {BARO Sensor} Refer to: DTC P2228-P2230 or P227C-P227E
- {MAP Sensor} Refer to: DTC P0106, P0107, or P0108
- {Turbocharger Boost Sensor} Refer to: DTC P0236, P0237, or P0238
- Go to next step: If in the specified range
- All OK.