Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0010, P0013, P2088, P2089, P2090, P2091
- Camshaft Position Actuator Solenoid Valve = On
- Ignition Switch Position = Run/Crank
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P0011, P0014
- DTC P0010, P0013, P2088, P2089, P2090, P2091 = Not set
- Desired Camshaft Position & Camshaft Position = 6 to 24°
- Desired Camshaft Position = Does not vary greater than 3° - For greater than 3 s
- Engine = Running
- Ignition Voltage = Greater than 11 V
- PTO Status = Inactive
Frequency the DTC runs = Continuously - After the running conditions are met