LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L (LSY)) >> Repair Instructions >> Engine Block Overhaul >> Engine Block Assemble Procedure

Engine Block Assemble Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5028823Courtesy of GENERAL MOTORS COMPANY

    Oil Flow Check Valve Seal (1) - Install NEW

  2. Oil Flow Check Valve (2) - Install
  3. GM5028819Courtesy of GENERAL MOTORS COMPANY

    Piston Oil Nozzle (1) - Install [4x]

    4. CAUTION:

    Fastener Caution

  4. Piston Oil Nozzle Bolt (2) - Install and tighten [4x] - Fastener Specifications 
  5. GM5028818Courtesy of GENERAL MOTORS COMPANY

    Cylinder Head Locating Pin (1) - Install [2x] - use KM-266  Remover/Installer

  6. GM5028816Courtesy of GENERAL MOTORS COMPANY

    Engine Block Core Hole Plug (1) - Install

  7. Guide Pin (2, 3) - Install [4x]
  8. GM5028801Courtesy of GENERAL MOTORS COMPANY

    Engine Coolant Temperature Sensor Seal (2) - Install NEW

    9. CAUTION:

    Refer to Component Fastener Tightening Caution .

  9. Engine Coolant Temperature Sensor (1) - Install and tighten - Fastener Specifications
  10. Engine Coolant Heater Hole Plug (4) - Install and tighten - Fastener Specifications 
  11. Starter Locating Pin (3) - Install [2x] - use J-26269  Remover/Installer
scientia non olet · About LEMON Manuals