Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Remove the tensioner side and non-tensioner side timing chain guides. Camshaft Timing Chain Replacement
Courtesy of GENERAL MOTORS COMPANY

Engine Wiring Harness Ground Bolt (1) - Remove
Engine Ground Cable (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Camshaft Carrier (1) - Remove - Camshaft Carrier Replacement
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold (1) - Remove - Intake Manifold Replacement
Courtesy of GENERAL MOTORS COMPANY

Direct Fuel Injection Fuel Rail (2) - Remove - Fuel Injection Fuel Rail Assembly Replacement
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Pump (2) - Remove - Evaporative Emission Canister Purge Pump Replacement
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Heat Shield (2) - Remove - Turbocharger Heat Shield Replacement
Courtesy of GENERAL MOTORS COMPANY

Engine Coolant Thermostat Housing Inlet Pipe (2) - Remove - Engine Coolant Thermostat Housing Inlet Pipe Replacement (LSY)
Courtesy of GENERAL MOTORS COMPANY

Positive Crankcase Ventilation Oil Separator (3) - Remove - Positive Crankcase Ventilation Oil Separator Replacement
Courtesy of GENERAL MOTORS COMPANY

Engine Mount Bracket (2) - Install - Engine Mount Bracket Replacement
Courtesy of GENERAL MOTORS COMPANY

Engine Mount (3) - Install - Engine Mount Replacement
Courtesy of GENERAL MOTORS COMPANY

Engine Support Fixture (1) @ Cylinder Head - Remove - Engine Support Fixture
Courtesy of GENERAL MOTORS COMPANY

Cylinder Head Bolt (1) - Remove and DISCARD [10x]
Cylinder Head (2) - Remove
Cylinder Head Gasket (3) - Remove and DISCARD
Clean, inspect and overhaul the cylinder head as needed. Cylinder Head Overhaul