Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
Brake Pipe Fitting (1) - Remove
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Brake Hose Bracket Nut (1) - Remove
Brake Hose Fitting Bolt (1) - Remove
- Brake Hose Fitting Gasket (2) @ Brake Hose Fitting (3) - Remove and DISCARD [2x]
- Plug the brake caliper inlet to prevent brake fluid loss and contamination.
- Rear Brake Hose (3) - Remove
NOTE:
Do NOT reuse the brake hose fitting gaskets.