Removal Procedure
WARNING:
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Remove the brake master cylinder assembly from the vehicle. Brake Master Cylinder Replacement - With Power Brake Booster and Electronic Brake Control Module
Brake Master Cylinder Bracket Bolt (1) - Remove [2x]
- Brake Master Cylinder Bracket (2) - Remove and DISCARD
- Front Floor Console Extension Panel - Left Side - Remove Front Floor Console Extension Panel Replacement - Left Side
- Instrument Panel Lower Airbag - Driver Side - Remove Instrument Panel Lower Airbag Replacement - Driver Side
Electrical Connector (1) @ Brake Pedal Position Sensor - Disconnect
- Electrical Connector @ Accelerator Pedal Position Sensor - Disconnect
- Wiring Harness Retainer @ Brake and Accelerator Pedal Assembly - Remove
Brake Pedal Bracket Bolt (1) - Remove
Brake Pedal Bracket Bolt (1) - Remove [2x]
- Brake and Accelerator Pedal Assembly - Remove
Accelerator Pedal with Position Sensor Assembly (2) - Remove - Accelerator Pedal with Position Sensor Assembly Replacement
- Transfer components as necessary.