Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Thoroughly clean the brake master cylinder reservoir and the brake master cylinder body to remove any dirt and debris.
- Using a suitable tool, remove and properly dispose of the brake fluid from the brake master cylinder reservoir.
- Brake Master Cylinder - Remove - Brake Master Cylinder Replacement - With Power Brake Booster and Electronic Brake Control Module
Brake Master Cylinder Bolt (1) - Remove [2x]
Brake Master Cylinder Reservoir (1) - Remove
Brake Master Cylinder Reservoir Grommet (1) - Remove and DISCARD [3x]
- Transfer components as needed.
WARNING:
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
WARNING:
Refer to Brake Fluid Irritant Warning .
CAUTION:
Refer to Brake Fluid Effects on Paint and Electrical Components Caution .