LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Diagnostic Information and Procedures >> DTC C2A1B >> Circuit/System Verification

Circuit/System Verification

  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC C2A1B is not set.
    • If the DTC is set 
    1. Perform the scan tool configuration/reset function: Brake System Plunger Pressure Rise Starting Point Learn
    2. Clear DTCs
    3. Verify DTC C2A1B is not set.
      • If DTC C2A1B is set

        Test or replace the component: A104 Brake Master Cylinder

      • Go to next step: If DTC C2A1B is not set

        Go to next step: All OK.

    • Go to next step: If the DTC is not set 
  3. All OK.
scientia non olet · About LEMON Manuals