Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P026B, P05EC, P16F3
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P2227, P2228, P2229, P2230 = Not set
- Engine Speed = Greater than 680 RPM
- Frequency the DTC runs = Continuously - After the running conditions are met
P0601, P0602, P0604, P0605, P0607, P060A, P060B, P0610, P061C, P0630, P160A, P160D, P160E, P161C, P264F, P3191
- Ignition = On
- Frequency the DTC runs = Continuously - After the running conditions are met
P0603, P062F
- Ignition = On
- Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met
P0606, P062B, P16E9-P16F0, P30D6-P30DD
- Run/Crank = Greater than 11 V
- Frequency the DTC runs = Continuously - After the running conditions are met
P064D, P064E, P134C, P27B5
- Battery Voltage = Greater than 11 V
- Engine = Running - Greater than 3 min
P2610, P262B
- Run/Crank = Inactive
- Frequency the DTC runs = Once - After ignition Off - After the running conditions are met - For 20 s