Component Testing

S86 Vehicle Stability Control Switch

1. Ignition/Vehicle - Off
2. Disconnect the electrical connector: S86 Vehicle Stability Control Switch
3. Test for infinite resistance between the test points: Signal terminal 2 & Ground terminal 6 - Not Pressed
   • If less than infinite resistance 

     Replace the component: S86 Vehicle Stability Control Switch

   • Go to next step: If infinite resistance 
4. Test for less than 3 ohms between the test points: Signal terminal 2 & Ground terminal 6 - Pressed
   • If 3 ohms or greater 

     Replace the component: S86 Vehicle Stability Control Switch

   • Go to next step: If less than 3 ohms 
5. All OK.

M91 Instrument Panel Compartment Door Unlatch Actuator-Dynamic Test

1. Ignition/Vehicle - Off
2. Disconnect the electrical connector: M91 Instrument Panel Compartment Door Unlatch Actuator
3. Connect a jumper wire between the test points: Ground terminal 2 & Ground
4. Momentarily connect a 10 A fused jumper wire between the test points: Control terminal 1 & 12 V

   Verify the component turns On and Off when connecting and disconnecting the jumper wire: M91 Instrument Panel Compartment Door Unlatch Actuator

   • If the component does not turn On and Off 

     Replace the component: M91 Instrument Panel Compartment Door Unlatch Actuator

   • Go to next step: If the component turns On and Off 
5. All OK.