LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer L >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 9T50 (M3D), 9T60 (M3T) Or 9T65 (M3V) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Torque Converter Replacement

Torque Converter Replacement

GM4375607Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Transmission Replacement (All Wheel Drive) , or Transmission Replacement (Front Wheel Drive) 
  2. Position the transmission assembly so the torque converter is facing up.
1 Torque Converter Assembly
CAUTION:

Only install the lift assist handles until it stops. Do not tighten. Over tightening the lift assist handles can cause damage to the torque converter.

CAUTION:

Lower the torque converter straight down. Failure to lower the torque converter straight down could damage the torque converter clutch lip seal inside the torque converter clutch assembly.


Special Tools 
DT-46409  Torque Converter Lifting Handles
For equivalent regional tools, refer to Special Tools .