Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Remove the electrical harness bracket nuts (1).
- Remove the electrical harness bracket (2) from the control valve body cover and position out of the way.
- Drain the transmission fluid. Transmission Fluid Drain and Fill
Disconnect the control valve body transmission control module electrical connector (1), then unclip the wiring harness from the cover.
Transmission Fluid Cooler Inlet Pipe (1) @ Transmission - Disconnect - Transmission Fluid Cooler Inlet Pipe Replacement (LCV, LGX, without V08) , or Transmission Fluid Cooler Inlet Pipe Replacement (LGX, with V08)
Transmission Fluid Cooler Outlet Pipe (2) @ Transmission - Disconnect - Transmission Fluid Cooler Outlet Pipe Replacement (LGX, with V08) , or Transmission Fluid Cooler Outlet Pipe Replacement (LCV, LGX, without V08)
- Remove the body ground cable and wiring harness assembly mounting bolt at front of transmission and position ground cable and harness out of the way.
-
Courtesy of GENERAL MOTORS COMPANY
Remove the control valve body cover bolts (1, 2).
Remove the control valve body cover (1).
- Clean the transmission case and control valve body cover gasket surfaces. Inspect and replace the gasket as necessary.