Control Valve Body Cover Installation

Fig 1: Exploded View Of Control Valve Body Cover Components With Tightening Sequence

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Body Side Wiring Harness Opening Seal Procedure  Install a NEW seal. Do NOT reuse the old seal.
2	Control Valve Body Cover Gasket Procedure  Install a NEW gasket. Do NOT reuse the old gasket.
3	Control Valve Body Cover
4	Control Valve Body Cover Bolt [6x] CAUTION: Refer to Fastener Caution . Tighten in sequence  11 N.m (8 lb ft)
5	Control Valve Body Cover Stud [6x] Tighten in sequence  11 N.m (8 lb ft)