Auxiliary Fluid Accumulator Installation

Fig 1: Exploded View Of Auxiliary Fluid Accumulator Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Accumulator Bypass Valve Seal Procedure  Install a NEW seal.
2	Shift On/Off Solenoid Valve with Automatic Transmission Auxiliary Fluid Accumulator Solenoid Cover NOTE: Repair or replace as necessary An Automatic Transmission Auxiliary Fluid Accumulator Solenoid Cover MUST be installed over the Valve. If there was no Automatic Transmission Auxiliary Fluid Accumulator Solenoid Cover during removal, a NEW Shift On/Off Solenoid Valve and Automatic Transmission Auxiliary Fluid Accumulator Solenoid Cover must be installed. The Cover is not available separately.
3	Accumulator Valve Body Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten  2.7 N.m (24 lb in)
4	Automatic Transmission Case Seal [2x] Procedure  Install a NEW seal.
5	Accumulator Bypass Valve Seal Procedure  Install a NEW seal.
6	Automatic Transmission Auxiliary Fluid Accumulator
7	Automatic Transmission Auxiliary Fluid Accumulator Bolt [3x] Tighten  22 N.m (16 lb ft)