Circuit/System Verification
- Verify the condition does not exist: Incorrect fluid level or condition - Refer to Transmission Fluid Level and Condition Check
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- If a condition exists
- Ignition - On / Vehicle - In Service Mode
- Clear DTCs
- Road test the vehicle. Refer to Road Test
- Verify DTC P0716, P0717, P0721, P0722, P0723, P07BF, P077C, P077D, P07C0, P176B, P176C, P176D, P17D3, P2731, P2820, P2821 is not set.
- If DTC P0716, P0717, P0721, P0722, P0723, P07BF, P077C, P077D, P07C0, P176B, P176C, P176D, P17D3 is set
- If any DTC listed in the DTC Descriptor Category is set
Refer to: Diagnostic Fault Information
- Go to next step: If none of the DTCs listed in the DTC Descriptor Category is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P0716, P0717, P0721, P0722, P0723, P07BF, P077C, P077D, P07C0, P176B, P176C, P176D, P17D3, P2731, P2820, P2821 is not set.
- If DTC P0716, P0717, P0721, P0722, P0723, P07BF, P077C, P077D, P07C0, P176B, P176C, P176D, P17D3 is set
- If any DTC listed in the DTC Descriptor Category is set
Refer to: Diagnostic Fault Information
- Go to next step: If none of the DTCs listed in the DTC Descriptor Category is set
- All OK.