Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify there are no DTCs set related to the following component/system: Serial Data
- If other DTCs are set
- If no other DTCs are set
- Ignition/Vehicle - Off
- Replace the component: K17 Electronic Brake Control Module
- Operate the vehicle within the Conditions for Running the DTC.
Verify the DTC does not set.
- If the DTC sets - Replace the component: K71 Transmission Control Module
- Go to next step: If the DTC is not set
- All OK.
- Go to next step: If no DTC is set
- All OK.