Installation Procedure
- Install the left rear intermediate pipe from the vehicle.
- Position, but do not secure, the left rear intermediate pipe to the retaining clips.
- CAUTION:
Refer to Fastener Caution .
Install the left rear intermediate pipe fitting (1) to the rear brake hose fitting and tighten the fitting to 18 N.m (13 lb ft).
Secure the left rear intermediate pipe to the left rear rail retaining clips (1).
Secure the left rear intermediate pipe to the left rail retaining clips (1).
Secure the left rear intermediate pipe to the cross vehicle retaining clips (1).
Secure the left rear intermediate pipe to the retaining clips (1).
Secure the left rear intermediate pipe to the rear floor retaining clips (1).
- Install the fuel tank. Refer to Fuel Tank Replacement (AWD) , and Fuel Tank Replacement .
Install the underbody cross sill shield (1) and the 2 nuts.
Secure the left rear intermediate pipe to the front floor retaining clips (1).
Secure the left rear intermediate pipe to the retaining clip (1).
Secure the left rear intermediate pipe to the retaining clips (1).
Connect the left rear intermediate pipe fitting (1) to the BPMV and tighten the fitting to 18 N.m (13 lb ft).
- Install the battery. Refer to Battery Replacement .
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) , and Hydraulic Brake System Bleeding (Pressure) .