LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Trax LS, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Rear Brake Hose Replacement (Drum Brake) >> Installation Procedure

Installation Procedure

  1. Install the brake hose.
  2. GM2778568Courtesy of GENERAL MOTORS COMPANY

    Install the brake hose retainer (1).

    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the brake pipe fitting (1) to the rear brake hose and tighten the fitting to 18 N.m (13 lb ft).
  4. GM2772261Courtesy of GENERAL MOTORS COMPANY

    Install the brake hose to the wheelhouse bracket and install the retainer (1).

  5. GM2772260Courtesy of GENERAL MOTORS COMPANY

    Install the brake pipe fitting (1) to the rear brake hose and tighten the fitting to 18 N.m (13 lb ft).

  6. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) , and Hydraulic Brake System Bleeding (Pressure) .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals