Installation Procedure
- Install the power brake booster vacuum hose assembly to the vehicle.
- NOTE:
A small amount of denatured alcohol may be used as a lubricant for assembly.
Release the clamp and install the power brake booster vacuum sensor (1).
- NOTE:
A small amount of denatured alcohol may be used as a lubricant for assembly.
Install the power brake booster vacuum sensor and hose assembly (1) to the power vacuum brake booster grommet.
- Connect the power brake booster vacuum sensor electrical connector.
Connect the power brake booster vacuum hose quick connect (1) to the intake manifold vacuum port.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Through the left front wheelhouse, connect the power brake booster vacuum hose quick connect (1) to the power brake booster pump port.