LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Trax LS, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Front Brake Hose Replacement >> Removal Procedure

Removal Procedure

WARNING:

Refer to Brake Dust Warning .

WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. GM2512985Courtesy of GENERAL MOTORS COMPANY

    Remove the brake pipe fitting (1) from the front brake hose.

  4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
  5. GM2396312Courtesy of GENERAL MOTORS COMPANY

    Remove the brake hose retainer (1).

  6. GM2396315Courtesy of GENERAL MOTORS COMPANY

    Release the brake hose grommet (1) from the strut bracket.

  7. GM2387041Courtesy of GENERAL MOTORS COMPANY

    Remove the brake hose fitting bolt (1).

    8. NOTE:

    Do not reuse the brake hose fitting gaskets.

  8. Remove and discard the brake hose fitting gaskets (2) from the brake hose fitting (3).
  9. Remove the brake hose.
scientia non olet · About LEMON Manuals