LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Trax LS, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Proportion Valve Replacement >> Installation Procedure

Installation Procedure

  1. GM2511333Courtesy of GENERAL MOTORS COMPANY

    Install the proportion valve (1).

  2. GM2511331Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Install the proportion valve nut (1) and tighten to 15 N.m (11 lb ft).

  3. GM2511329Courtesy of GENERAL MOTORS COMPANY

    Connect the left rear brake pipe fitting (1) and tighten to 18 N.m (13 lb ft).

  4. GM2511328Courtesy of GENERAL MOTORS COMPANY

    Connect the right front brake pipe fitting (1) and tighten to 18 N.m (13 lb ft).

  5. GM2511327Courtesy of GENERAL MOTORS COMPANY

    Connect the left front brake pipe fitting (1) and tighten to 18 N.m (13 lb ft).

  6. GM2511325Courtesy of GENERAL MOTORS COMPANY

    Connect the right rear brake pipe fitting (1) and tighten to 18 N.m (13 lb ft).

  7. GM2511304Courtesy of GENERAL MOTORS COMPANY

    Connect the master cylinder primary brake pipe fitting (1) to the brake proportion valve and tighten to 18 N.m (13 lb ft).

  8. GM2511302Courtesy of GENERAL MOTORS COMPANY

    Connect the master cylinder secondary brake pipe fitting (1) to the brake proportion valve and tighten to 18 N.m (13 lb ft).

  9. Install the battery. Refer to Battery Replacement .
  10. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) , and Hydraulic Brake System Bleeding (Pressure) .
scientia non olet · About LEMON Manuals