Installation Procedure

Install the brake pipe to the vehicle.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install the BPMV front pipe fitting (1) to the BPMV and tighten the fitting to 18 N.m (13 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Install the BPMV front pipe fitting (1) to the master cylinder and tighten the fitting to 18 N.m (13 lb ft).
Install the battery. Refer to Battery Replacement .
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) , and Hydraulic Brake System Bleeding (Pressure) .