Installation Procedure

Install the BPMV front brake pipe to the vehicle.
Position, but do not secure, the BPMV front brake pipe to the retaining clips.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install the BPMV front brake pipe fitting (1) to the right front brake hose and tighten the fitting to 18 N.m (13 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Secure the BPMV front brake pipe to the retaining clip (1).
Lower the vehicle to access the upper brake pipe retaining clips.
Courtesy of GENERAL MOTORS COMPANY

Secure the BPMV front brake pipe to the retaining clips (1).
Courtesy of GENERAL MOTORS COMPANY

Install the BPMV front brake pipe fitting (1) to the BPMV and tighten the fitting to 18 N.m (13 lb ft).
Install the battery. Refer to Battery Replacement .
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) , and Hydraulic Brake System Bleeding (Pressure) .
Install the right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .