LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Traverse LS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Displays And Gauges >> Diagnostic Information and Procedures >> DTC B124F >> Circuit/System Verification

Circuit/System Verification

  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC B124F is not set.
    • If the DTC is set 
    1. Perform all necessary programming and setup procedures for the control module: P16 Instrument Cluster
    2. Verify the DTC does not set.
      • If the DTC sets - Replace the component: P16 Instrument Cluster
      • Go to next step: If the DTC is not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  3. All OK.
scientia non olet · About LEMON Manuals