Circuit/System Verification

Ignition - On/Vehicle - In Service Mode
Verify the component activates: Radio Speaker The balance and fade controls can be used to help isolate an inoperative speaker or poor sound condition.
- If the component does not activate
  Refer to: Speaker Malfunction (IOS) , or Speaker Malfunction (IOR) , or Speaker Malfunction (IOT) .
- Go to next step: If all components operate
B153D Seat Belt Buckle - Driver & B153P Seat Belt Buckle - Passenger - Buckled
Verify the scan tool parameter: Driver Seat Belt Status & Passenger Seat Belt Status = Buckled
- If not the specified state
  Refer to: Seat Belt Indicator Malfunction - Driver .
- Go to next step: If the specified state
Headlamp Switch - Off
Verify the scan tool parameter: Headlamps On Switch = Inactive
- If not the specified state
  Refer to: Headlamps Malfunction
- Go to next step: If the specified state
Park Lamps Switch - Off
Verify the scan tool parameter: Park Lamps Switch = Inactive
- If not the specified state
  Refer to: Park, License, and/or Tail Lamps Malfunction
- Go to next step: If the specified state
Turn Signal Switch - Off
Verify the scan tool parameter: Left Turn Signal Switch & Right Turn Signal Switch = Inactive
- If not the specified state
  Refer to: Park, License, and/or Tail Lamps Malfunction
- Go to next step: If the specified state
Close the doors and verify that the luggage compartment is empty.
Verify the scan tool parameter: Driver Door Ajar Switch & Passenger Door Ajar Switch & Left Rear Door Ajar Switch & Right Rear Door Ajar Switch = Inactive
- If not the specified state
  Refer to: Door Ajar Indicator Malfunction
- Go to next step: If the specified state
All OK.